|
- Change oil filter with no spills
- Optional designs
- Formed to capture oil filter mount drippings
- Or funnel oil into your change pan
- Positions
beneath oil filter and filter mount, stays in place
- Made of tough ABS
plastic, easy clean-up
- Also for transmission, primary, fuel etc.
- Fits Electra Glides, Road Glides and Road Kings with front mount oil filter
- Use our Soft Dry Towel after you wash you bike
|
|
|
|
|
|
|
|
|
|
Front Mounted Oil Filter Change Funnel |
|
|
|
Oil Drain Pan for Harleys |
|
|
|
Transmission/Crankcase Fill Funnel |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Oil Change Handler - Left Side Oil Tank |
|
|
|
|
|
OF-1: For all Harley Davidson™ Evo and TwinCam 1985 to current with forward spin on oil filter. Fits all
Touring, Dyna, Softail, and Sportsters. Look, no mess. Just imagine - Slide, punch, twist. And with those
three quick moves your oil is draining into our funnel instead of all over the rubber front engine mount of your Harley. With
your motorcycle still leaning on its stand, slip in this Oil Filter Drain Funnel, punch a drain hole in the top of the filter,
twist the filter 180 degrees and then relax. When empty, finish spinning the filter off. This particular design
fits most new Harley Davidson models except for V-Rods. It even fits forward control bikes or those with crankcase sensors.
Included with the Funnel is a punch and tube for getting the oil past the lower fairing. ODP-95: Reduce the mess
and cleanup required when changing the fluids on your motorcycle. This reusable Drain Pan is designed specifically for use
with Harley-Davidson® motorcycles. The low-profile design fits easily under standard height and lowered motorcycles, and
slips beneath the bike even when on the side stand. The 10-quart capacity will capture 2 engine oil changes or the complete
drain fluids (engine oil, primary and transmission) from one motorcycle. The Drain Pan is large enough to catch the oil from
the entire length of the primary, and is sized to hold and drain an inverted primary cover. The Drain Pan features a raised
hardware corral, a filter drain surface, and a pressure vent hole to prevent messy oil burping. The drained waste oil is sealed
safely inside the pan with high-quality gasketed caps and plugs. Convenient carrying handle simplifies transport to an approved
waste oil facility. TC-10: Fill your transmission and crankcase without the mess. This funnel is shaped to fit into tight
spaces, and is designed to reach even the toughest access points. The anti-burp design insures smooth oil flow, and the smooth
orange or blue plastic surface is easy to clean after use. PO-10: This re-usable patent pending funnel makes it easy to add oil to your primary cavity. The funnel simply snaps into
the derby cover opening to permit hands-free filling. The flat cone shape makes it easy to fill a tight area with no mess
or spills. Smooth orange plastic surface is easy to clean after use. Fits '07-later Twin Cam models. PO-15: This re-usable funnel makes it easy to add
oil to your primary cavity. The funnel simply snaps into the derby cover opening to permit hands-free filling on the specified
models. The convenient tab allows you to place the funnel in position with one hand, and the flat cone shape makes it easy
to fill a tight area with no mess or spills. Smooth orange plastic surface is easy to clean after use. Fits '84-later Evo
1340-equipped models and '99-'05 Dyna®, '00-'06 Softail® and '99-'06 Touring Twin Cam-equipped models.
FT-09: The Fill & Go fuel tank adapter eliminates fuel spills
and splash back during fill-ups, and reduces time at the pump. Just insert the Fill & Go over the fuel pump nozzle, and
begin filling-up. When the pump clicks off, your tank is full, with no need to top off the tank. Kit includes Fill & Go
tank adapter and a convenient storage pouch. Available in orange or yellow.
OH-1: Fit all Harley Davidson™ Evo and TwinCam models with spin-on oil filter.
Tired of the clean-up needed after changing the oil filter on your Electra Glide? The OH-1 positions itself below the
oil filter and mount, and in between the filter, voltage regulator and front cylinder where it captures oil
drippings as you remove the filter. This particular design approach simplifies the oil change process
with no mess or drips. The OH-1 is designed to stay in place and not interfere with the filter removal. A must
for all Electra Glide oil changes! OH-2: Available for
early model FLH Electra Glides with left side mount oil tank. Using an Oil Handler is the easy way to direct the
oil from the oil tank when performing an oil change. A funnel doesn't work well...can't handle the flow. The Oil
Handler provides a trough to flow the oil from the tank to your disposal reservoir with no spills. It's designed to
fit underneath the oil drain plug and is positioned between rear of the outer primary and saddlebag. A notch is provided
for bikes equipped with saddlebag guards. The Oil Handler positions itself to stay in place as the oil drains.
Made of tough ABS plastic and formed to direct the oil with no spills. Manufactured in the U.S.A.
Take the hardest part of changing your fluids out with our fluid change
products and enjoy the ride.
SDT-91: Made of synthetic material that is safe for use on all surface
finishes. Ensures extra absorbency without streaking. Stays soft and supple even when dry. Durable, mildew-resistant and machine
washable. 12" x 21" towel.
|
 |
|
Photos:
|
| OF-1 Oil Change Funnel |
|
| ODP-95 Oil Drain Pan |
|
| TC-10 Transmission/Crankcase Fill Funnel (orange or blue) |
|
| PO-10 Primary Oil Fill Funnel |
|
| PO-10 Primary Oil Change Funnel |
|
| PO-15 Primary Oil Change Funnel |
|
| FT-09 Fuel Tank Fill-N-Go Funnel (orange or yellow) |
|
| ODP-95 Oil Drain Pan |
|
| OH-2 Oil Change Handler |
|
|
|
|
| SDT-91 Soft Drying Towel |
|
|
|
|
|
|
